Delta 3 H.P. SINGLE-STAGE DUST COLLECTOR 50-853 - Manual (Page 12)

12
Fig. 32
Fig. 33
Fig. 34
Fig. 35
MODEL 50-853
SINGLE PHASE
INSTALLATION
Your dust collector is supplied with a motor and
controller; however, it is not supplied with a power cord
and plug.
1. To connect the dust collector to a power system,
remove controller cover (A) Fig. 34.
2. Bring the single phase power line through the
access hole (B) Fig. 34, in the top of controller box and
connect the two power lines to terminals (E) Fig. 35, and
the green ground wire to ground screw (F).
3. After connecting the power cord to the machine, the fan
should rotate in a clockwise direction. WARNING: DO
NOT INSERT FINGERS OR ANY FOREIGN OBJECT
INTO THE DUST INTAKE PORT.
A
B
B
A
C
D
F
E
MODEL 50-852
THREE PHASE
INSTALLATION
Your dust collector is supplied with a motor and
controller; however, it is not supplied with a power cord
and plug.
1. To connect the dust collector to a power system,
remove controller cover (A) Fig. 32.
2. Bring three phase power line through the access
hole (B) Fig. 32, in the top of controller box and connect
the three power lines to terminals (C) Fig. 33, and the
green ground wire to ground screw (D).
3. After connecting the power cord to the machine,
make certain the rotation of the motor is in the proper
direction by viewing the rotation of the blower fan. The
fan should rotate in a clockwise direction.
WARNING:
DO NOT INSERT FINGERS OR ANY FOREIGN
OBJECT INTO THE DUST INTAKE PORT. Rotation of
the motor can be reversed by interchanging any two of
the three incoming power lines connected to terminals
(C) Fig. 33.