Luxul XAP-1040 - Manual (Page 16)

User Guide
16 © Copyright 2014 Luxul. All rights reserved. Trademarks & Registered Trademarks are property of respective holders.
c. Enter the user name and password (default user name is ”admin” and default
password is “admin”), and then click “OK” to login to the Quick Setup window.
5.2 Quick Setup
Quick Setup: For most installations, it is expected that the Quick Setup page will
be suffi cient to optimally confi gure and deploy the XAP-1040 Wi-Fi network. The
Quick Setup page consists of the following:

DHCP Client: Enabled or Disabled. DHCP (Dynamic Host Confi guration Protocol)
is used to automatically assign an IP Addresses to a device on the network. If
DHCP is enabled on the Access Point, it will no longer use the static address set
by Luxul at time of manufacturing and will request a dynamic IP Address from the
Router (sometimes referred to as the Gateway).
When DHCP is enabled on the Access Point, the new IP address will be needed in
order to access the web management interface. The Router web interface can be
used to look up the IP address assigned to the Access Point. To Enable DHCP, click
on the drop down menu and select
Enable. Select Apply and then Reboot for the
change to take effect.