Lingenfelter L850131410 Camaro Ram Air Hood v 0.8 - Manual (Page 6)

Page 5.
10. The hood is connected by two (2) 13 mm
nuts on the driver and passenger side (four nuts
total). Loosen the two (2) nuts on the driver side
but do not remove them completely.
11. Loosen the two (2) nuts on the passenger
side but do not remove them completely.
12. Locate the hood prop snap fitting on the
underside of the hood. You need to insert a small
flat head screwdriver into the slot behind the
retaining ring as shown.
9. Disconnect the windshield washer water
line connector by squeezing the connector and
pulling the two lines apart.