Lingenfelter L850131410 Camaro Ram Air Hood v 0.8 - Manual (Page 10)

Page
27. Close the hood and check for alignment
on the passenger and driver side, as well as
the front of the hood relative to the fascia. You
may need to repeat steps 11-17 several times to
properly align the hood with the fenders and front
fascia.
28. Using a pry tool (or equivalent), remove
the three (3) windshield washer water line
retaining clips from the stock hood.
26. This illustration shows the other rubber
hood adjusters location on the hoods hinge.
9.
25. Using a 13 mm socket and ratchet, torque
the four (4) hood nuts to the hood mounting
brackets and adjust as necessary to properly
align the hood. Torque these nuts to 18 ft-lbs (25
N-m). The hood bolts can move in any direction
so you may need to repeat this process several
times in order to properly align the hood.