Lingenfelter L460220000 Lingenfelter TBRC-001 Temperature Based Relay Controller v1.0 - Manual (Page 6)

Page 5.
Troubleshooting
If you believe that the TBRC-001 is switching at an incorrect temperature, check the following:
• Use a multimeter to measure the sensor’s resistance at a certain temperature. Then, compare the resistance to the
resistance values on the sensor type vs. sensor resistance chart on page 7.
• Check to varify that you have set the 16 position (sensor type and hysteresis) switch to the correct range for your
sensor type.
NOTICES:
It is the responsibility of the purchaser to follow all guidelines and safety procedures supplied with this product and any
other manufacturer’s product used with this product.
Lingenfelter Performance Engineering assumes no responsibility for damages resulting from accident, improper
installation, misuse, abuse, improper operation, lack of reasonable care, or all previously stated reasons due to
incompatibility with other manufacturer’s products.
Lingenfelter Performance Engineering assumes no responsibility or liability for damages incurred from the use of products
manufactured or sold by Lingenfelter Performance Engineering on vehicles used for competition racing.
It is the purchaser’s responsibility to check the state and local laws and sanctioning body requirements pertaining to the
use of this product for racing applications. Lingenfelter Performance Engineering does not recommend nor condone the
use of its products for illegal street racing.
Limited Warranty:
LPE warrants the Lingenfelter TBRC-001 Temperature Based Relay Controller to be free from defects in material and
workmanship under normal use and if properly installed for a period of 90 days from date of purchase. If the module is
found to be defective as mentioned above, it will be replaced or repaired if returned prepaid along with proof of date of
purchase. This shall constitute the sole remedy of the purchaser and the sole liability of LPE. To the extent permitted
by law, the foregoing is exclusive and in lieu of all other warranties or representations whether expressed or implied,
including any implied warranty of merchantability or fitness. In no event shall LPE be liable for special or consequential
damages.
For additional product installation information and technical support, contact LPE or your LPE products
distributor. You can also find technical support and usage discussions regarding this product and many other
LPE products in our Internet forums:
http://www.lingenfelter.com/LPEforumfiles
Follow us on Facebook!
http://www.facebook.com/home.php#!/lpehp