Installing attachments, Warning – LEHR Eco Trimmer User Manual

Page 9

LEHR

Fig. 11

90° Edging

Hole

INSTALLING CUTTING ATTACHMENTS OR ADD-ONS

NOTE: Place the unit on the ground or on a work bench

to make accessory installation or removal easier.

1. Turn knob counterclockwise to loosen (Fig. 10).
2. While firmly holding the attachment, push it straight into

coupler (Fig. 10).

NOTE: Aligning the release button with receiving hole

will help installation (Fig. 10).

INSTALLING ATTACHMENTS

Fig. 10

Receiving Hole

Release Button

Coupler

Upper Shaft

Housing

Knob

Attachment

Housing

Line up parts

3. Turn the knob clockwise to tighten (Fig. 11). Unit is

ready to use.

4. For edging (when using the string trimmer head cut -

ting attachment) lock the release button of the cut -

ting attachment into the 90° edging hole (Fig. 11), so

that the engine remains in the upright position while

operating.

NOTE: Lock the release button in the receiving hole and

securely tighten the knob before operating this unit.

NOTE: Attachments are to be used in the receiving hole

only. Using the wrong hole could lead to personal injury

or damage to the unit.

NOTE: Always install the attachment so that the engine

is upright (propane tank on bottom) when unit is oper -

ated. A secondary receiving hole is provided for use of a

trimmer being used for edging only. No other accessory

should be used in this secondary hole (90° edging hole)

( Fig. 11).

REMOVING CUTTING ATTACHMENTS OR ADD-ONS

1. Turn the knob counterclockwise to loosen (Fig. 12).
2. Press and hold the release button (Fig. 12).
3. While firmly holding the upper shaft housing, pull

the cutting attachment or add-on straight out of the

coupler (Fig. 12).

Coupler

Fig. 12

Release Button

WARNING:

TO AVOID SERIOUS INJURY AND
DAMAGE TO THE UNIT, SHUT OFF
THE UNIT BEFORE REMOVING OR
INSTALLING ATTACHMENTS OR
ADD-ONS.