Assembly, Warning – LEHR Eco Trimmer User Manual

Page 5

LEHR

WARNING:

INSTALLING CUTTING ATTACHMENT SHIELD

Use the following instructions if the cutting attachment

shield on your unit is not installed. Use only the

instructions that apply to the type of shaft and shield

that your unit is equipped with.

FOR CURVED SHAFT TRIMMERS

Place the cutting attachment shield and spacer against

tube as shown in (Fig. 1). Use the 2 screws provided

to clamp the cap and shield onto the tube. Tighten the

screws evenly. Make sure the shield does not touch

any rotating parts.

FOR STRAIGHT SHAFT TRIMMERS

Place the cutting attachment shield onto the shaft

mount. Install using provided hardware in the sequence

as shown (Fig.2).

Cutting Attachment Shield

Spacer

Cap

Attaching Screws

Washer

Fig. 1

Fig. 2

Cutting Attachment Shield

Shaft Mount

Plate Washer

Washer

Lock W asher Attaching Screws

INSTALLING THE D-HANDLE AND LOWER HANDLE

STRAIGHT SHAFT AND ACCESSORY READY
TRIMMERS

1.Locate the 4 screws included in the tool kit.
2.Assemble the upper and lower handle parts and 4

screws as shown in (Fig. 3), positioning the handle

parts evenly over the rubber sleeve on shaft. Do not

completely tighten.

3.While holding the unit in the operating position (Fig.

14), position the D-handle to the location that pro-

vides you the best grip.

4.Tighten the clamp screws evenly, until the D-Handle

is secure.

Fig. 3

Attaching

Screws

D-Handle

Lower Handle

CURVED SHAFT TRIMMERS

1. Installing the D-Handle (non detachable model).

2. Installing D-Handle over the tube in desired position.

3. Install the fasteners as shown (Fig. 4).

4.Tighten until D-Handle is secure.

Fig. 4

D-Handle

Fasteners

ASSEMBLY

To prevent serious injury, never operate the
trimmer without the cutting attachment in
place.