LEHR Eco Trimmer - Manual (Page 15)

LEHR | ALL RIGHT RESERVED 2008-2009 15
Fig.24
Bump Feed
Button
Hole
TRIMMER HEAD LINE INSTALLATION
SMALL BUMP FEED HEAD (.080” Line)
1. Review figure 28 for names of parts referred to in these
instructions.
2. Lock shaft by inserting allen key into hole in collar and turn
until it engages groove inside. When shaft can no longer
rotate, loosen head by turning it as shown (Fig. 24).
3. Loosen bump feed button and remove by turning CCW
(Fig. 25).
Fig.25
4. Pull reel out of trimmer body, take care to not lose
the spring behind it.
5. Un-wind and remove the remnants of the line left on
the reel. Note how the ends of the line are hooked in
place and the direction it is wound.
6. If using new line from a bulk spool, cut 2 pieces of
line 7.5 ft (2.28 m) long. Insert each line into one of
the holes on each retention hook opposite of the
direction of the rotation about1/2 inch deep.
7. Wrap line 180° and wind extra line in the opposite
direction of rotation of the head as shown (Fig. 26).
Fig. 26
Wire Reel
Retention
Hook
Retention
Hook
NOTE: Always use original equipment manufacturer replacement line. Lines other than those
specified may make the engine overheat or fail.
8. Continue winding cord in direction indicated as
shown, leave about 6 inches free length (15-20 cm)
to pull wire through holes in body. Snap the lines
through top notches in reel (Fig. 26 and Fig. 27).
Wrap Bottom CCW
Hook
Wrap Top CCW
Hook
Fig. 27
9. Feed the free ends of
lines through holes in
body while inserting
reel back into body.
Hold reel in place
against spring pres -
sure (Fig. 28).
Trimmer Head
Body
Spring
Reel
Bump Feed
Button
Nut
Fig.28
10. While holding reel into body, screw bump feed but -
ton and nut onto threads by turning CW (Fig. 29).
Fig.29
Fig.30
11. Insert allen key into hole tighten by turning body as
shown (Fig. 30).
MAINTENANCE