Labconco FreeZone 2.5 Liter Freeze Dry Systems 76705 Series - Manual (Page 22)

Chapter 4: Using Your Freeze Dryer
Product Service 816-333-8811 or 1-800-522-7658 18
To configure your Freeze Dryer, turn the main power switch ON and press MENU.
The display will show:
 Press SELECT until the desired units are flashing.
 Press MENU.
 The display will show:
Where YYY is the units selected above.
 Press SELECT until the desired vacuum operating level is displayed. See
“Setting the Operating Vacuum Level” for guidelines.
 If “0” is selected, the vacuum control is disabled and the vacuum level in
the Freeze Dry System will be determined by the capabilities of the
vacuum pump.
 Press MENU.
 The display will show:
 Press SELECT until the desired units are flashing.
 Press MENU.
 The display will show:
VACUUM UNITS
mBar
Pa Torr
TEMPERATURE UNITS
°C
°F
REFRIG TOTAL HOUR: XXXX
SERVICE HOUR: XXXX
VACUUM SET POINT
XXXX
YYY