Lab.gruppen LM 44 - Manual (Page 26)

20
Quick Start Tutorial
Lake LM Series Quick Start and Field Reference Guide Rev 1.2.8
26. Tap any of the four magnifying glass icons on the right-side of Module A’s block diagram to open the
Output Configuration screen.
27. Verify that the Output Configuration is routed as shown in Figure 6-1 below where Source = Module
Outputs and Destination = Analog Outputs.
Figure 6-1: Classic 3+1 Analog Output Configuration
28. If the output assignments are not as shown, tap the Clear All Assignments button (split arrows);
tap YES to the warning dialog box; then tap the numeric buttons correctly route the audio to the
appropriate physical output/s.
29. Tap the return key to close this screen and return to I/O CONFIG.
30. The following settings on the left-side of the I/O CONFIG screen should be correct by default; if they
are incorrect, please refer to the Lake Controller Operation Manual for further details.
▸ PRIMARY DIGITAL CLOCK:
Internal – 96 kHz
▸ SRC CLOCK:
Internal – 88.2 kHz
▸ INPUT CONFIGURATION:
#1: Auto Type: Analog Offset/Headroom: 26 dBu
#2: Auto Type: Analog Offset/Headroom: 26 dBu
▸ DANTE CONFIGURATION:
Dante Disabled
▸ ANALOG ISO-FLOAT & AES TERMINATION:
Inputs 1-2: Floating
Outputs 1-6: Floating AES: Terminated