Konig Electronic Indoor pan-tilt IP camera remote video surveillance - Manual (Page 8)

ENGLISH
8
3
Searching Wi‑Fi Router
The status LED will flash green until the
Wi-Fi router is found (up to 5 minutes).
Once the router is found, the status LED
will become orange.
If the IP camera cannot connect to the
Wi-Fi router, please check the Wi-Fi
router status or re-install.
In the app, select the camera name
that is shown in the Camera List, and
the viewing window will open (see
“Figure 15”).
Figure 15
Add already installed IP camera to the app
ANDROID (for Apple go to: Step 5)
1
Open the “uCare Cam” app and select n the Camera List
Window screen (see “Figure 16”) for adding an IP camera.
2
Select the tab:
Your device will now enter the QR code mode.
Note: you need to have a QR code scanner installed on your device.
3
Locate the QR code on the backside of the IP camera and scan the
QR code. After scanning the QR code, the UID (Unique ID code)
appears in the screen of your device (see “Figure 17”).
4
Enter a personal camera name and password and select the tab:
(see “Figure 17”).
The new camera will be added to the list (see “Figure 18”).