Konig Electronic WLAN router 300 Mbps - Manual (Page 5)

5
LED INDICATORS
LED status Description
Status Green flash Device status is working
Green RJ45 cable is plugged in
WAN LED
Green flash Data access
Green RJ45 cable is plugged in
LAN LED
Green flash Data access
Green Wi-Fi is on
Green flash Data access
Green fast flash Device is in WPS PBC mode
Wi-Fi LED
Dark green Wi-Fi is disabled
BUTTON DEFINITION
Description
CMP-WNROUT55
When wireless is switched on, press and hold this button (about 1 sec) to execute
WPS function
WPS CMP-WNROUT60
1. When wireless is switched off, press and hold this button (about 1 sec) to
enable “Wireless Radio”
2. When wireless is switched on, press and hold this button (about 1 sec) to
execute WPS function
Wireless On
(CMP-WNROUT55
only)
When wireless is switched off, press and hold this button (about 1 sec) to enable
“Wireless Radio”
CMP-WNROUT55
1. Press this button and switch on the device
2. Press and hold for about 3 – 4 seconds. The device will reset to the default
settings. Then the Status LED flashes every second in Normal status
Notice: If the Status LED flashes very fast, it means this button was pressed too
long. Please try again Reset
CMP-WNROUT60
Press and hold this button for 6 seconds to reset to default settings. Release the
button when the device works simultaneously.