Light bulb replacement – Dimension One Spas AQUATIC FITNESS SYSTEM 2003 User Manual
Page 30
Aquatic Fitness System
2003 Owner’s Manual
Light Bulb Replacement
All systems are equipped with a 12-volt light using a GE912 bulb. To change the bulb:
1. Turn the power off and drain the system below the level of the
light.
2. Using the special tool provided in the owner’s manual
packet, unscrew the cover for the light housing.
3. Remove the old bulb and install the new bulb.
4. Use the special tool to replace the cover for the light
housing.
5. Check to ensure proper operation of the new bulb before
refilling the system.
Do not attempt to remove the light housing cover without lowering the water level
below the light housing cover.
Do not attempt to remove the light housing cover without the special tool. If you are not
able to locate it, contact the Dimension One Spas’ Service Department to have one sent.
Be sure the O-ring is not damaged and is properly in place when replacing the lens.
Contact Dimension One Spas if a replacement O-ring is needed.
A Dynamic L.E.D. Light is available as an optional accessory for many models. This
light is preprogrammed with 13 different light shows. This light is also replaced in the
same manner as described in the previous paragraph. Contact your dealer or visit our
Virtual Showroom at
to see if it is available for your model.
26