Kent Razo E17 - Manual (Page 13)

INSTRUCTIONS FOR USE
Razor E17
— 909 6311 000(1)2006-01 11
SOLUTION FILTER CLEANING
1. Empty the solution tank (5, Fig. I) according to the
procedure shown in the relevant paragraph.
2. Drive the machine on a level ground.
3. Make sure that the power supply cable (21, Fig. C) is
disconnected from the electrical mains.
4. Remove the transparent cover (1, Fig. G) and the filter
strainer (2); clean and reinstall them on the support (3).
MACHINE SPEED ADJUSTMENT
1. Remove the recovery water tank as shown in the Use
chapter.
2. Adjust the machine speed by means of the screw (11,
Fig. I), according to the following procedure:
– Loosen the screw (16, Fig. I) on the right side of
the machine, by turning it counter-clockwise;
– Turn the adjusting screw (11, Fig. I)
counter-clockwise to increase the machine speed;
– Turn the adjusting screw (11, Fig. I) clockwise to
decrease the machine speed;
– After adjusting, tighten the screw (16, Fig. I).
3. Install the recovery water tank as shown in the Use
chapter.
4. With the machine ready to operate, carry out hands-on
tests of the machine and, if other adjustments are
necessary, repeat steps 1 to 4.
TROUBLESHOOTING
For further information refer to the Service Manual, available
at any KENT Service Center.
NOTE
Properly install the filter strainer (2, Fig. G) in
the housing (4) of the support (3).
NOTE
The machine speed depends on the floor type
and on the choice of using brush or pad.
The machine speed can be adjusted according
to the following procedure.
TROUBLE REMEDY
No motor ignition
Power supply cable faulty or
disconnected from the electrical
mains
Insufficient dirty water
vacuuming
Recovery water tank full
Clogged vacuum grid or stuck closed
float
Vacuum hose disconnected from the
squeegee or faulty
Dirty squeegee, or worn or damaged
squeegee blades
Improperly closed recovery water
tank cover; worn gasket or clogged
compensation hole
Insufficient solution flow to
the brush/pad
Dirty solution filter
Dirty recovery water tank (clogged
drain hole)
Squeegee-related marks
Debris under the squeegee blades
Worn, chipped or torn squeegee
blades