Imaxrc X400 twins - Manual (Page 21)

31 32
Cut off Low Input
Backlight Level
Cut off Temperature
Buzzer
Cut off Capacity
Language
Cut off Time
Back
Select output mode
NixxDeltaPeak
Waste Time
Cycle Time
Range of setting:10-24V. Lowest cut off input voltage, charger will stop charging/
discharging when input voltage is lower than setting value.
Range of setting: 1-10, Brightness level.
Range of setting: 40-80°C. Cut off Temperature, charger will stop charging/
discharging when temp of batteries is lower than setting value.
Range of setting: All sounds open, only touch tone closed, All sounds closed.
Range of setting: 0.1Ah-10Ah. Safety capacity. Charger will Stop charging/dis-
charging when capacity of batteries is higher than setting value.
Language option. Now provisionally only support English interface.
Range of setting: 10-200mins. Safety time, charger will stop charging/dis-
charging, when charging/discharging time is less that setting value.
【IMPORTANT NOTICE】 X400Twins charger has 3 parameters to control rotate speed of
fan.
1. When temperature of working charger reach 40℃, fan speed will be one level up as temp
rise by each 2℃
2. When charging power reach 100W, fan speed will be one level up as charging power rise
by each 5W.
3. Fan speed will be one level up as discharging power rise by each 2W.
NOTE: Fan Speed of X400Twins charger will begin to change in any of above situ-
ation.
Turn back to main interface
When select single output, the maximum output can reach 20A and 400W.
When select dual output, each maximum output can reach 15A and 200W.
Range of setting: 5-200mV. NiHm/NiCd Delta peak.
Spacinge interval between 2 Cycles. Rang of setting: 1-60mins.
Range of setting: 1-6 times. Cut off
Low
Input
Cut off
tempe-
raturey
Cut off
Capacity
Cut off
Time
Nixx
Delta
Peak
Wasle
Time
Cycle
Times
Backlight
Level
Buzzer
Language
Back
Chapter 2 Enjoy function of X400Twins Chapter 2 Enjoy function of X400Twins