HITEC Optic 5 2.4 - Manual (Page 14)

Page 13
ID-Setup A.K.A, Link or Bind
Set-up and Use of the Hitec 2.4GHz System
To turn the system on and off, use the following sequence at all times.
Turning Off -Turn off the receiver, then turn off the transmitter. Turning On -Turn on the transmitter, then turn on the receiver.
Minima Series Receiver Features
Press and hold the button on the front of the transmitter, and turn on
the transmitter. Release the link button.
Release the LINK button.
Press and hold the LINK button on the Receiver
and turn on the power.
Both the RED and BLUE LEDs will
blink rapidly to find the transmitter
signal. Release the LINK button when
the RED LED on receiver glows
steady.
When the link is completed, the BLUE LED on the transmiter
will blink while the BLUE LED on the receiver glows steady.
(when using telemetry receivers, both BLUE & RED LEDs
will glow steady) Turn off and on the transmitter and receiver again to save
the setting.
5
5
2.4GHz 6 Channel 2. 4G Hz 6 C ha nn el
Aircraft Receiver Ai rc ra ft Re ce ive r
2.4GHz 6 Channel 2. 4G Hz 6 C ha nn el
Aircraft Receiver Ai rc ra ft Re ce ive r
Channel
2.
4GHz
6
C
ha
nn
el
Receiver
Ai
rc
ra
ft
Re
ce
ive
r
Please check that the LED blinks
BLUE. If the LED blinks RED,
press the LINK button for one second
until the LED turns BLUE. (BLUE LED -
binding mode for Minima series; RED
LED - binding mode for Optima series).
Non-telemetr
y RXs
(MINIMA & MICRO S
eries)
Telemetr
y RXs (OPTIMA S
eries)