HITEC Gemini - Manual (Page 15)

15
# 21 4224
Examine your kit carefully!
MULTIPLEX model kits are subject to constant quality checks throughout the production process, and we sincerely hope
that you are completely satisfied with the contents of your kit. However, we would ask you to check all the parts (referring
to the Parts List) before you start construction, as we cannot exchange components which you have already
worked on. If you find any part is not acceptable for any reason, please take the kit back to your model shop in the first
instance, as he will be able to advise you. After checking, he will send the component or the kit to our Quality Control
department. We can only process guarantee claims if the purchase receipt and a brief description of the fault are
supplied.
We are constantly working on improving our models, and for this reason we must reserve the right to change the kit
contents in terms of shape or dimensions of parts, technology, materials and fittings, without prior notification. Please
understand that we cannot entertain claims against us if the kit contents do not agree in every respect with the
instructions and the illustrations.
Caution!
Radio-controlled models, and especially model aircraft, are by no means playthings. Building and operating
them safely requires a certain level of technical competence and manual skill, together with discipline and a
responsible attitude at the flying field. Errors and carelessness in building and flying the model can result in
serious personal injury and damage to property. Since we, as manufacturers, have no control over the
construction, maintenance and operation of our products, we are obliged to take this opportunity to point out
these hazards and to emphasise your personal responsibility.
Additional items required:
e.g. MULTIPLEX Micro IPD receiver 35 MHz, A-band Order No. 5 5971
alternatively 40 MHz Order No. 5 5972
or MULTIPLEX RX-7 SYNTH DS IPD receiver 35 MHz, A-band Order No. 5 5885
MULTIPLEX Nano-S servo 2 x required for ailerons Order No. 6 5120
2 x required for elevator / rudder
Servo extension lead 3 required for aileron servos Order No. 8 5031
Standard powerset for basic aerobatics HiMax HC 2816-0890 Order No.33 2634
Contents: 1 HC 2816-0890 motor
1 APC 10” x 5” E propeller
1 Driver for Elapor spinner, 4 mm Ø split taper collet
1 BL 27 speed controller
Tuning-powerset for 3D-aerobatics HiMax HC 3516-1130 Order No.33 2631
Contents: 1 HC 3516-1130 motor
1 propeller APC 10” x 5” E + APC 11x 5,5“ E for AkroMaster
1 Driver for Elapor spinner, 5 mm Ø split taper collet
1 speed controller Phoenix 45
1
Motor mount
Flight battery:
MULTIPLEX flight pack, e.g. LiBatt 3/1-2100 mAh (load capacity approx. 36 A)
Order No. 15 7131
Adhesive: cyano-acrylate
Use medium and high-viscosity cyano-acrylate glue (”cyano” - not styrofoam cyano) for this model. Epoxy adhesives
produce what initially appears to be a sound joint, but the bond is only superficial, and the hard resin breaks away from
the parts under load. Hot-melt glue (from a glue gun) is an excellent alternative adhesive, especially for servo mounting.
Tools:
Scissors, balsa knife, combination pliers, long pointed-nose pliers, slot-head / cross-point screwdrivers (for the servo
output arm screws).
Note: remove the picture pages from the centre of the building instructions.
GB