Heath Consultants Remote Methane Leak Detector Intrinsically Safe (RMLD-I) - Manual (Page 16)

Fig. 3-2: RMLD-IS rear panel
Headphone port: receptacle for the headphone plug.
Power Switch: depress the switch to turn the instrument on/off.
Ext. Power: receptacle for the external power to charge unit.
RS-232 port: receptacle for a DB-9 connector for interfacing to a PC (used for
factory calibration purposes only).
Turning the RMLD-IS On
Depress the power switch located on the rear panel. When the unit first turns on the
green spotter laser will briefly flash and the display will shortly show all of the icons.
The display will then return to its run display mode showing the ppm-m reading. The
warning icon will also shortly display as the laser starts up. This warning should turn off
after a few seconds. The instrument will turn on with the same settings (e.g., Alarm
Detection Threshold, Spotter On, etc.) as when it was turned off.
**Note**
The infrared detection laser is continuously on and the instrument is measuring the
methane concentration while the instrument is on.
RS-232 port
External power port
Power switch
Headphone port
101296-0 RMLD IS MANUAL REV J
Page 16 of 40