Hatteland Display HT B22 (Fanless) - Manual (Page 20)

DOC101357-1_ - rev 2 – 2013-09-23 - Created by:6644
Page 20 of 25
Hatteland Display AS, Åmsosen, N-5578 Nedre Vats, Norway
Tel: (+47) 4814 2200 - [email protected] - www.hatteland-display.com
HD CAN Module Programmer’s Guide (Windows)
All intellectual properties belongs to Hatteland Display AS
i) J2534_ERROR_CODE J2534::PassThruReadVersion
(
unsigned
long
DeviceID,
char *
pFirmwareVer
sion,
char * pLibVersion,
char * pApiVersion
)
This function returns the version strings associated with the library. If the function is
successful, a value of STATUS_NOERROR is returned. A buffer of at least eighty (80)
characters must be allocated for each pointer by the application.
Parameters:
[in] DeviceID Device ID returned from PassThruOpen.
[out] *pFirmwareVersion Pointer to Firmware version string.
[out] *pLibVersion Pointer to library version string.
[out] *pApiVersion Pointer to API version string in YY. MM format.
Returns:
Status, see function return codes in hdj2534.h .
Note:
THIS FUNCTION IS NOT IMPLEMENTED. It is only provided to comply with
the J2534 specification.
j)
J2534_ERROR_CODE J2534::PassThruSetProgramm
ingVoltage
(
unsigned
long
DeviceID,
unsigned
long PinNumb
er,
unsigned
long
Voltage
)
This function sets a single programming voltage on a single specific pin.
Parameters:
[in] DeviceID Device ID returned from PassThruOpen.
[in] PinNumber The pin on which the programming voltage will be set.
[in] Voltage The voltage (in millivolts) to be set.
Returns:
Status (Always ERR_NOT_SUPPORTED), see function return codes in hdj2534.h .
Note:
THIS FUNCTION IS NOT IMPLEMENTED. It is only provided to comply with
the J2534 specification.