Hanna Instruments HI 9813-0 User Manual

Page 8

CE DECLARATION OF CONFORMITY

Hanna Instruments reserves the right to modify the design, construction and

appearance of its products without advance notice.

All rights are reserved. Reproduction in whole or in part is prohibited without the
written consent of the copyright owner.

ACCESSORIES

PROBES

HI 1285-0

Combination, amplified pH/EC/TDS probe with built-in
temperature sensor, 8-pin DIN connector and 1 m
(3.3') cable

HI 1285-5

Combination, amplified pH/EC/TDS/temperature probe
with built-in temperature sensor, 8-pin DIN connector
and 1 m (3.3') cable

HI 1285-6

Combination, amplified pH/EC/TDS/temperature probe
with Cal-Check feature, built-in temperature sensor, 8-
pin DIN connector and 1 m (3.3') cable

pH BUFFER SOLUTIONS

HI 7004L

pH 4.01 buffer solution, 500 mL bottle

HI 7006L

pH 6.86 buffer solution, 500 mL bottle

HI 7007L

pH 7.01 buffer solution, 500 mL bottle

HI 7009L

pH 9.18 buffer solution, 500 mL bottle

HI 7010L

pH 10.01 buffer solution, 500 mL bottle

CONDUCTIVITY & TDS CALIBRATION SOLUTIONS

HI 7031L

1413 µS/cm solution, 500 mL bottle

HI 7442L

1500 ppm (mg/L) solution, 500 mL bottle

OTHER SOLUTIONS

HI 700661P Cleaning solution, 20 mL sachet (25 pcs)
HI 50021P Check solution, 20 mL sachet (25 pcs)
HI 70300L

Storage solution, 500 mL bottle

HI 7073L

Protein cleaning solution, 500 mL bottle

HI 7074L

Inorganic cleaning solution, 500 mL bottle

HI 7077L

Oil & Fat cleaning solution, 500 mL bottle

OTHER ACCESSORIES

ChecktempC Electronic thermometer (-50.0 to 150.0°C)
HI 710015

Shockproof rubber boot, blue

HI 710016

Shockproof rubber boot, orange

HI 710022

Blue protective case

Recommendations for Users
Before using these products, make sure that they are entirely suitable for the environment in which they
are used. Operation of these instruments in residential areas could cause unacceptable interferences to
radio and TV equipment.
The glass bulb at the end of the electrode is sensitive to electrostatic discharges. Avoid touching this glass
bulb at all times. During operation, ESD wrist straps should be worn to avoid possible damage to the
electrode by electrostatic discharges.
Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC
performance.
To avoid electrical shock, do not use these instruments when voltages at the measurement surface exceed
24VAC or 60VDC.
To avoid damages or burns, do not perform any measurement in microwave ovens.