Hanna Instruments HI 95729 - Manual (Page 3)

3
Please examine this product carefully. Make sure that the instrument is not damaged. If any
damage occurred during shipment, please notify your Dealer.
Each
HI 95729 Ion Selective Meter is supplied complete with:
• Two Sample Cuvets and Caps
• 9V Battery
• Two CAL CHECK
TM Cuvets (HI 95729-11) with Quality Certificate
• Tissue for wiping cuvets
• One 2000 µL automatic pipette with Instruction Sheet
• One plastic tip for 2000 µL automatic pipette
• Instruction Manual and Quick Reference Guide
• Instrument Quality Certificate
• Rigid carrying case
Note:save all packing material until you are sure that the instrument works correctly.
Any defective item must be returned in its original packing.
PRELIMINARY EXAMINATION
18
REAGENT SETS
HI 93729-01
Reagents for 100 tests
HI 93729-03 Reagents for 300 tests
OTHER ACCESSORIES
HI 93703-53
Chlorine Remover
HI 95729-11 CAL CHECK TM Standard Cuvets (1 set)
HI 710009 Blue rubber boot
HI 710010 Orange rubber boot
HI 721310 9V battery (10 pcs)
HI 731318 Tissue for wiping cuvets (4 pcs)
HI 731331 Glass cuvets (4 pcs)
HI 731335 Caps for cuvets (4 pcs)
HI 731342 2000 µL automatic pipette
HI 731352 tips for 2000 µL automatic pipette (4 pcs)
HI 93703-50 Cuvets cleaning solution (230 mL)
Battery replacement must only take place in a
non-hazardous area.
Simply slide off the battery cover on the back of
the meter. Detach the battery from the terminals
and attach a fresh 9V battery while paying attention
to the correct polarity. Insert the battery and replace
the cover.
9V
SLIDE
OFF
FACTORY CALIBRATION RESET
It is possible to restore factory calibration:
• Enter the
calibration mode by holding CAL CHECK
for three seconds .
• Hold ZERO for 10 seconds. The display will
show for 2 seconds “F.CAL” and "729" appears.
The factory calibration is automatically restored
and the instrument is ready for measurement.
BATTERY REPLACEMENT
ACCESSORIES