Ce declaration of conformity, Accessories, Battery replacement – Hanna Instruments HI 93124 User Manual

Page 8

CE DECLARATION OF CONFORMITY

Recommendations for Users

Before using this product, make sure that it is entirely suitable for the environment in which it is used.
Operation of this instrument in residential area could cause unacceptable interferences to radio and TV equipments,
requiring the operator to take all necessary steps to correct interferences.
Any variation introduced by the user to the supplied equipment may degrade the instrument's EMC performance.
To avoid electrical shock, do not use this instrument when voltages at the measurement surface exceed 24VAC or
60VDC.
To avoid damages or burns, do not perform any measurement in microwave ovens.

Hanna Instruments reserves the right to modify the design, construction and
appearance of its products without advance notice.

ACCESSORIES

HI 93124-0

Calibration solution, 0 EBC, 30 mL bottle

HI 93124-1

Calibration solution, 2.5 EBC, 30 mL bottle

HI 93124-2

Calibration solution, 125 EBC, 30 mL bottle

HI 93124-03

EBC Haze calibration set (HI 93124-0, HI 93124-1, HI
93124-2)

731318

Tissue for wiping cuvettes (4 pcs)

HI 731321

Spare measurement cuvettes (4 pcs)

92000

Windows

compatible application software

920011

5 to 9-pin RS232 connection cable

HI 93703-50

Cleaning solution, 230 mL bottle

BATTERY REPLACEMENT

In order to minimize the battery consumption, the meter is equipped with an auto-
shut off function which switches the meter off after 5 minutes of non-use.
The meter is powered by 4 alkaline batteries (1.5V AA), which are constantly
monitored by the meter to ensure reliable readings.
A "LO BAT" indication will appear on the display
when the batteries become weak and require
replacement; the instrument can perform only 50
more measurements.
A "0% LO BAT" message will appear on the display
when the batteries level is too low for performing
measurements; the message appears for a few
seconds, then the meter automatically shuts off;
immediately replace the batteries.
Battery replacement must only take place in a non hazardous area using 4 alkaline
batteries, 1.5V AA size.
Turn the meter off, unscrew the 2 screws on the back of the instrument and remove
the battery cover. Substitute the rundown batteries with new ones, while paying
attention to their polarity. Reattach the battery cover and tighten the 2 screws.