Connecting the ipod – Dodge 2010 Charger User Manual
Page 232
This feature allows an iPod
to be plugged into the
vehicle’s sound system through a 16–pin connector, using
the provided interface cable.
UCI supports Mini, 4G, Photo, Nano, 5G iPod
and
iPhone
devices. Some iPod software versions may not
fully support the UCI features. Please visit Apple’s
website for software updates.
NOTE:
• If the radio has a USB port, connecting an iPod to this
port does not play the media. For playing an iPod
,
use the separate 16–pin connector port (in the glove
compartment on some vehicles).
• Connecting an iPod to the AUX port located in the
radio faceplate, plays media, but does not use the UCI
feature to control the connected device.
Connecting The iPod
ா
Use the provided connection cable to connect an iPod
to
the vehicle’s 16–pin connector port (which is located in
the glove compartment on some vehicles). Once the
iPod
is connected and synchronized to the vehicle’s UCI
system (iPod
may take a few seconds to connect), the
iPod
starts charging and is ready for use by pressing
radio switches, as described below.
NOTE:
• It may be necessary to remove the connector pin
protection cap from the 16–pin connector port, prior to
connecting the cable.
• If the iPod battery is completely discharged, it may
not communicate with the UCI system until a mini-
mum charge is attained. Leaving the iPod
connected
to the UCI system may charge it to the required level.
4
UNDERSTANDING YOUR INSTRUMENT PANEL
231