Hall Research TVB-200PLUS - Manual (Page 15)

TV-to-VGA Converter
13
4.3 Serial Command Set
Configure port for: 4800 Baud, 8-bits, no parity, 1 stop bit
Command Description
D1[enter] Restore Defaults
I0[enter] Auto Scan
Ix[enter] Select Input ( x=1:CV1, 2: CV2, 3:S-Vid, 4:VGA)
Bx[enter] Brightness set & Save ( 0 < x < 255)
^Bx[enter] Brightness set ( 0 < x < 255)
Cx[enter] Contrast set & Save ( 0 < x < 127)
^Cx[enter] Contrast set ( 0 < x < 127)
Vx[enter] Volume set & Save for current input selection ( 0 < x < 255)
^Vx[enter] Volume set ( 0 < x < 255)
Sx[enter] Saturation set & Save( 0 < x < 127)
^Sx[enter] Saturation set ( 0 < x < 127)
Hx[enter] Hue set ( 0 < x < 255)
^Hx[enter] Hue set ( 0 < x < 255)
Ox[enter] OSD Control (x=0:Off, 1:On)
Fx[enter] Front Panel Control (x=0:Off or Disabled, 1:On or active)
Gx[enter] Gamma Enhancement Level ( x=1:1.3, 2:1.5, 3:1.8)
Nx[enter] NTSC ( x=1:Configure Specifically for NTSC, 0:Other or Auto)
Rx [enter] Read Bus (follow instructions)
** FOR ADVANCED USE ONLY **
Wx [enter] Write Bus (follow instructions)
** FOR ADVANCED USE ONLY **