Gryphon Mirage - Manual (Page 15)

NOTE: When the display is
turned completely off, pressing
any button on the front panel or
on the remote will cause the dis-
play to turn on briefly so that you
can see the current volume level
and selected input. Press a sec-
ond time to activate the desired
function.
Restoring Default
Settings
You can delete all of your custom
Menu settings and return to the
factory pre-set default settings.
Doing so deletes all input
names, sets Maximum Level at
50, sets Start Level at 00, sets
Brightness at 100% and sets
Input 3 as a normal audio input.
When RESTORE SETTINGS
appears in the display, press
Monitor. RESTORE? appears in
the first line of the display. NO
and YES appear in the second
line. NO will blink. If you do NOT
wish to delete your custom set-
tings, press Monitor, while NO is
blinking, then press Menu to
select the next menu-controlled
function. If you do wish to delete
all your custom settings, press
Input Up until YES blinks, then
press Monitor. You have now
deleted all your custom settings.
The factory pre-set default set-
tings are now in effect.
RESTORE SETTINGS will
appear in the display. Press
15
Menu to select the next menu-
controlled function.
Assigning Input 3 as
a Dedicated AV
Connection
You can use the Mirage with a
stereoamplifier in a normal
stereo set-up but using a sepa-
rate surround processor, you
can connect the left and right
front channels from your sur-
round processor to Input 3 of the
Mirage and using the Menu to
configure this input so that the
signal bypasses all preamplifier
stages in the Mirage. This allows
you to enjoy the full performance
of the Mirage for stereo and sur-
round listening without placing
any surround components in the
stereo signal path.
CAUTION: When Input 3 is set
up as a dedicated AV connec-
tion, the Mirage’s volume control
is automatically set at a fixed
level. The signal from the sur-
round processor goes to the
Mirage power amplifier section
and MUST be calibrated and
attenuated by the surround
processor.
When DEDICATE INP.3 TO AV
appears in the display, press
Menu to select the next menu-
controlled function, if you do