Go Power! GP-3000HD - Manual (Page 8)

Go Power! Modified Sine Wave Inverter
Owner’s Manual
www.gpelectric.com 8
4.0 Installation
4.1 Where to Install
The power inverter should be installed in a location that meets the following requirements:
Do not connect this inverter and another AC source (generator or utility
power) to the AC wiring or AC loads at the same time. Doing so will
destroy the inverter and void the warranty, regardless whether the
inverter is switched on or off. If you are using more than one AC source
for the AC wiring or AC loads, it is highly recommended that you install
an automatic transfer switch (GP-TS), available from Go Power!
a) Dry: Do not allow water to drip or splash on the inverter.
b) Cool: Ambient air temperature should be between 32 – 104 °F (0 – 40 °C).
c) Ventilated: Allow at least 2” (5 cm) of clearance around the inverter for air flow.
Ensure the ventilation openings on the rear and bottom of the unit are not obstructed.
d) Safe: Do not install the inverter in the same compartment as batteries or in any
compartment capable of igniting flammable liquids such as gasoline.
e) The inverter should be located within 10 ft (3 m) of the batteries.
4.2 Connecting and Testing
The following section describes how to connect and test the GP-3000HD inverters.
A reverse polarity connection will permanently damage the inverter.
Damage caused by reverse polarity connection is not covered by the
warranty.
This inverter must only be connected to batteries with a nominal output
voltage of 12 V. Lower voltages will not operate the inverter properly,
and higher voltages could damage the inverter or the device being
powered. If more than one 12 V battery is used, the batteries must be
connected in a parallel circuit; batteries connected in a series circuit will
produce too much voltage.
You may observe a spark when you make this connection since current
may flow to charge capacitors in the power inverter. Do not make this
connection in the presence of flammable fumes, as explosion or fire may
result.
1. Unpack and inspect your Go Power! inverter. Ensure that the power switch is in the
OFF position.
2. Install the inverters on a flat surface, ensure that it has adequate ventilation and is not
in direct sunlight. Securely fasten the inverter to the surface. We recommend using
GP-DC Install Kits whenever installing a GP Inverter.; see section 4.3 DC Install Kits.