Delta 36-978 - Manual (Page 13)

13
Always disconnect the machine from
the power source before performing any maintenance
procedures.
Check the condition of the dust bag periodically for damage.
Empty the dust bag on a regular basis. Do not transport the
machine with a full dust bag.
Clean and apply a dry silicone lubricant monthly to the
impeller to remove any dirt or build-up of pitch, gum and wood
shavings.
Always make sure that the intake cap
(A) Fig. 27 covers the intake port when the hose is not
connected to the machine.
MAINTENANCE
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet. Also, check
for blown fuses or open circuit breakers in the line.
A complete line of accessories is available from your Delta Supplier, Porter-Cable
• Delta Factory Service Centers, and Delta
Authorized Service Stations. Please visit our Web Site www.deltamachinery.com for a catalog or for the name of your nearest
supplier.
Since accessories other than those offered by Delta have not been tested with this product, use of such
accessories could be hazardous. For safest operation, only Delta recommended accessories should be used with this
product.
ACCESSORIES
SERVICE
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at servicenet.deltamachinery.com.
You can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278 to
receive personalized support from highly-trained technicians.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about Delta Machinery, its factory-
owned branches, or an Authorized Warranty Service Center, visit our website at www.deltamachinery.com or call our Customer
Care Center at 1-800-223-7278. All repairs made by our service centers are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at Delta Machinery, 4825 Highway 45 North, Jackson, Tennessee 38305 - Attention:
Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number, type, serial number,
etc.)
A
Fig. 27