Generalmusic RP-X - Manual (Page 14)

Page 10
owners manual
rp-x
r p - x
r p - x
REV - REV +
r p - x
Tune - Tune +
Etc.
SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): REV SELECTING THE PARAMETERS TO EDIT IN THE SELECTED PARTS (CH): REV
THE MODE "ALL" IN EDIT MENU THE MODE "ALL" IN EDIT MENU
As already described in the previuos page, the ALL
mode is a way offer by the rp-x system to speed up
the editing operation for some parameters.
In fact setting the ALL mode in PART (CH) edit and selecting one of the edit parameters (*), the value you insert
affects all the parts at the same time.
(*) The SOUND selection it's excluded from the ALL mode.
VOLUME In ALL MODE sets the GENERAL volume of the instrument.
VELOCITY Allows you to set a programmable VELOCITY offset , in order to increase or decrease the velocity value
of incoming MIDI notes transmitted from a MIDI controller. Value range: -64/00/+64. Value=000
does not affects the original velocity values.
TRANSPOSE Sets the GLOBAL transpose of the module +/- 12 semitones. This value is added to the PART value.
The total transpose value is: +/- 36 semitones (+/- 24 semitones in PART, plus +/- 12 semitone in
ALL mode).
TUNE Control the GLOBAL tune of the module, from A = 427 to A= 452 Hz.
EFX Control the effect (EFX) general level.
REV Control the reverb (REV) general level.
Selecting the "ALL "mode the TUNE becomes a GLOBAL pa-
rameter. Editing this parameter the display indicates the detune
values in step of HERTZ. Range: from A = 427 to A= 452 Hz.,
A=440 standard default value.
NOTE
Set the REVERB (REV) level in the selected PART.
Press the EDIT button to select the REV. The display
indicates the current default value (REV=040), in this
example.
Pressing the DATA buttons to increase or de-
crease the REV send in the selected part. The display
shows you in realtime the value changing. The pa-
rameter range is from 0 to 127.