FeiYu Tech FY-40A - Manual (Page 5)

GuiLin FeiYu Electronic Technology Co., Ltd
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [email protected]
Page 5
0
+MAX -MAX
times, You will see the light flashes yellow. After YellowLED turns off, the mixing control mode
Setting is completed.
The mixed control setting will cycle changes like picture below shows:
9
、Gyroscope Reset
FY-40A has motion detection function, if it's moving, work mode indicator red LED will
become purple. But if the indicator LED still purple even when the FY-40A remains stationary,that
means you need to do the Gyro reset.
Initialization / Reset Process:
(1) Power on FY-40A and keep stationary.
(2) Switch to Auto stabilization mode.
(3) On SW, switch Auto stabilization mode to Deactivated mode 6 times, time interval has
to be less than 3 seconds as follows:
Auto stabilization mode
→ Deactivated mode →Auto stabilization mode →Deactivated mode
→Auto stabilization mode→ Deactivated mode →Auto stabilization mode →Deactivated mode
→Auto stabilization mode →Deactivated mode→Auto stabilization mode →Deactivated mode.
(4) FY-40A indicator will turn white about one second.
(5) After white LED turns off, the re-setting / initialization is completed.
10
、Adjustment Dials For ELE, AIL And RUD
(1) There are 3 adjustment dials on the
FY-40A. Each dial controls both gyro gain and
servo direction during auto stabilization.
Conventional layout
（No mixed control）
Aileron &Elevator
mixed control
E levator &Rudder
mixed control