EZ-ACCESS PATHWA MODULAR ACCESS SYSTEM - Manual (Page 20)

- 20 -
3.6. ANCHOR RAMP UPPER TRANSITION: The MRUT (RAMP UPPER TRANSITION)
must be anchored to a substantial surface. Use the pre-drilled holes at each corner of the
upper transition as guides.
3.6.1. IF RESTING ON A WOODEN SURFACE:
3.6.1.1. Secure upper transition by installing the 1/4 ″ self-drilling stainless
steel screw through each hole (FIG. 3.18).
3.6.2. IF RESTING ON A CONCRETE SURFACE:
3.6.2.1. Transfer the hole locations from the upper transition to the
concrete surface, then remove the upper transition.
3.6.2.2. Using a 1/4
″ masonry bit, drill two 1-1/2″ deep holes at the
marked locations. NOTE: After drilling, make sure that the holes
are free of any residue and/or debris.
3.6.2.3. Re-attach the upper transition and align over the drilled holes.
3.6.2.4. Drive the 1/4
″ diameter mushroom head pin anchors into the
holes on the upper transition with a hammer until the head is
seated.
FIG. 3.18