EXFO TG-300B Tone Generator - Manual (Page 15)

TG-300B/LFD-300B FiberFinder 10
Using the Optional Flexible Arm
The flexible arm is very useful when there is no surface, close enough to the fiber to
test or large enough, to lay the unit flat on its back.
To use the flexible arm with the TG­300B:
1. Adjust the clamp pressure using the adjustment screw.
2. Using the clamp, secure the flexible arm to a solid surface.
If necessary, readjust the clamp pressure as needed.
3. Using the threaded hole on the back of the TG­300B, screw it on the end of the
flexible arm.
4. Adjust the flexible arm to the desired position.
Flexible arm
Clamp
Threaded end
Adjustment screw
TG-300B back panel
Threaded hole