Delta 50-761 - Manual (Page 9)

9
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
ASSEMBLY
CASTERS
1. Turn stand (A) upside down, as shown in Fig 1C.
2. Place 3/8” lockwasher on caster stud (B) and
screw caster into threaded hole on the bottom of
the stand. Repeat for other three casters.
3. Tighten caster by hand, then set with a thin 14mm
wrench.
A
B
Fig. 1C
ATTACHING STAND TO LEGS ON
MOTOR/BLOWER ASSEMBLY
NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.
Place all four stand posts (A) Fig. 3 into four legs (B) on
motor/blower assembly. Make sure metal base plates
(D) are arranged over the large dust collection holes
(C).
Fig. 3
A
B
D
C
LEGS TO MOTOR/BLOWER
ASSEMBLY
1. Place motor/blower assembly with the motor (A)
Fig. 2 down.
2. Place 5/16” flatwasher on knob (B).
3.
Align holes on legs (C) with holes (D) in the
motor/blower assembly. Legs should extend up.
Insert knob through hole in the legs (C) and into
threaded hole in the motor/blower assembly (D).
Tighten knob securely.
4. Repeat steps for all knobs on both legs.
Fig. 2
A
D
C
B
THIS MACHINE IS HEAVY. USE TWO
OR MORE PEOPLE WHEN LIFTING.
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE - 30 minutes to 1 hour
* Phillips head screwdriver * 12 mm wrench