Delta 50-761 - Manual (Page 12)

12
Fig. 13
A
B
C
D
Fig. 11
Fig. 12
A
B
A
ATTACHING ACCESSORY HOSE
TO INTAKE PORT
DISCONNECT MACHINE FROM POWER
SOURCE BEFORE CONNECTING OR
DISCONNECTING HOSE .
Model 50-761 provides three 4” dust ports. Proceed as
follows for each port with your accessory hoses.
NOTE: Place open end (D) of intake cap rings around
and onto ends of each dust intake port before attaching
the hose.
To assemble the 4” dust collection hose (not supplied) to
the motor and blower assembly, loosely attach hose
clamp (A) Fig. 13, around one end of flexible hose (B)
and assemble the hose to dust intake port (C). Tighten
hose clamp (A). Assemble the remaining clamp to the
other end of the flexible hose and to the woodworking
machine.
NOTE: See “ACCESSORIES” section of this manual.
NOTE: Do not operate the dust collector with any of the
holes in dust intake port (C) Fig. 13 uncovered. To cover
a hole not being used by a hose, place the flat intake cap
(E) on dust intake port as shown in Fig. 13.
ATTACHING TOP FILTER BAG
1. Assemble 5/16” flatwasher (23 mm diam.) onto
5/16” hex head screw.
2. Position bracket (A) to dust collector as shown in
Fig. 11.
3. Insert 5/16” hex head screw through hole in bracket
and thread into the hole in dust collector. Tighten
securely with a 12 mm wrench.
4. Insert rod (A) Fig. 12 into pocket on filter bag.
5. Insert rod (A) into hole in bracket (B).
6. Work open end of filter bag into top groove of dust
collector drum until secure and sealed. It will be
necessary to bend and fold the internal bag retainer
ring to fit it into place.
7. Attach the other filter bag in the same manner.
E
DISCONNECT MACHINE FROM POWER
SOURCE