Delta 50-761 - Manual (Page 11)

11
A
Fig. 8
Fig. 9
B
Fig. 10
Fig. 10A
A
B
B
A
B
A
ATTACHING DUST COLLECTION BAG
USING CLOTH COVERED FLEXIBLE RING:
1. Take cloth-covered bag retainer ring (A) Fig. 8 and
place it inside opening of clear plastic dust
collection bag. Fold about 6 inches of the bag
down around the retainer ring.
2. Place bag in large hole (B) Fig. 8 in motor/blower
assembly and fit retainer ring (A) Fig. 8 and (A) Fig.
9 into bottom groove (B) Fig. 9. It will be necessary
to bend and fold the ring to fit it into place.
3. Tug slightly on bag to eliminate any slack and to
make sure there is a good fit so the bag will not
detach during collection.
USING METAL BAG CLAMP:
The plastic bag can also be attached to the outside of
the dust collector using the included clamp (B) Fig. 10:
1. Place clamp (B) around top of plastic bag (A) and
fold about 4 to 6 inches of plastic bag over the
clamp as show in Fig. 10.
2. Place the clamp and plastic bag assembly (A) Fig.
10A and fasten clamp securely as shown.
DISCONNECT MACHINE FROM
POWER SOURCE