Eviant T10 Series - Manual (Page 17)

- 12 -
Display Options & Channel Setup (continued)
Press the MENU button to return to the previous menu.
DTV Signal
In this item, it will display the signal strength of current ATSC channel.
Note: It is only available under ATSC channel.
Troubleshooting
Before contacting customer service, review the steps below to solve simple problems.
If you still suspect something wrong with this unit, immediately turn the power off,
disconnect the power connector from the unit, and contact Eviant Customer Service.
Never try to repair the unit yourself.
Problem Possible Cause Possible Solution
No broadcast signals in the
area or signals too weak Change location or try a more
powerful antenna
Unit set to receive CATV
signal Check antenna selection.
See page 10
Unit is in motion or
handheld Place unit on a stationary
surface.
Signal is obstructed by
buildings or other materials Change location or antenna
orientation
Channel selected is
unavailable Change Channel
See Page 10
No Signal
Source is set to AV and no
DVD or VCR is connoted Check source menu setting.
See page 5
Volume is turned down Check volume
No Sound
Audio language setting is
not correct Check audio language.
See page 7
Remote Control is out of
range Point Remote directly at front of
TV no more than 15 feet away
Remote Control
Does Not Work
Weak battery Replace CR2025 battery
Power switch is off or power
adapter is not connected
properly Check power switch and power
adapter connection
No Display
Weak battery Charge battery with power
adapter