Eskimo 69161 - Manual (Page 9)

Eskape ™ 200 Hardwater Series (69161)
HIGH PERFORMANCE ICE FISHING GEAR
®
Page 9
GetEskimo.com
1-800-345-6007
SET-uP & uSE INSTRuCTIONS
SET-uP: From the outside or inside of shelter, depending on your
preference, start with the bottom cross brace pole and pull out all
cross brace poles and snap into place. As you pull out each cross
brace pole and snap into place, flip all cross braces over to the in use
position. Secure all spreader poles in between all cross brace poles
by snapping C-clips over cross brace poles.
By removing the back spreader pole and the top back spreader pole,
you can flip the shelter half way back and use it as a wind break on
nice days.
TAKE-DOWN: Close all window covers, vent covers and zip door
shut. Remove all spreader poles and place in bottom of sled. Start-
ing with the rear cross brace pole, press the QRS pole clips in and
retract all cross brace poles to their shortest length. Work from the
rear cross brace to the front cross brace that lies on the ground/ice.
Flip all poles back into the transport position. Use extreme caution
when flipping poles for transport position and make sure no part of
the skin gets pinched, caught or stuck between any poles or in any
pinch points. Fold excess skin inside sled when complete.
NOTE: Use extreme caution so you don’t rip or tear any por-
tion of the skin, especially around the hinges or any pinch point
areas.