Eskimo 69163 - Manual (Page 9)

Eskape ™ 350 Hardwater Series (69163)
HIGH PERFORMANCE ICE FISHING GEAR
®
Page 9
GetEskimo.com
1-800-345-6007
SET-uP & uSE INSTRuCTIONS
SET-uP: From the outside or inside of shelter, depending on your
preference, start with the bottom cross brace pole and pull out all
cross brace poles and snap into place. As you pull out each cross
brace pole and snap into place, flip all cross braces over to the in use
position. Secure all spreader poles in between all cross brace poles
by snapping C-clips over cross brace poles.
By removing the back spreader pole and the top back spreader pole,
you can flip the shelter half way back and use it as a wind break on
nice day.
TAKE-DOWN: Close all window covers, vent covers and zip door
shut. Remove all spreader poles and place in bottom of sled. Re-
move any gear from the storage pockets. Starting with the rear cross
brace pole, press the QRS pole clips in and retract all cross brace
poles to their shortest length. Work from the rear cross brace to the
front cross brace that lies on the ground/ice. Flip all poles back into
the transport position. Use extreme caution when flipping poles for
transport position and make sure no part of the skin gets pinched,
caught or stuck between any poles or in any pinch points. Fold ex-
cess skin inside sled when complete.
NOTE: Use extreme caution so you don’t rip or tear any por-
tion of the skin, especially around the hinges or any pinch point
areas.