High performance ice fishing gear – Eskimo 69163 User Manual
Page 10

Eskape
™
350 Hardwater Series (69163)
Page 10
GetEskimo.com
HIGH PERFORMANCE ICE FISHING GEAR
1-800-345-6007
®
STANDARD ACCESSORIES
REmOVABlE GEAR TABlE
This gear table is designed to lock into the curled lip of the rear alumi-
num bench seat rail. It works just like the flip up seats, as you can flip
the table up and access gear underneath. Most anglers will remove
the center seat and put the table in so it is accessible to two anglers
at once, however, the table can certainly be positioned anywhere
along the bench seat rail, even to one end against the side of the
shelter if desired. Simply remove one of the seats from the aluminum
bench seat rail and replace it with the table. The table should always
be removed during transport so it does not get damaged and so a
travel cover accessory can snugly fit over the shelter for transport.
REmOVABlE ROD HOlDER
Depending on which model you have, your shelter has come stan-
dard with at least one rod holder assembly. This is designed to fit in
the T-slot portion of the front aluminum bench seat rail. With the built-
in plastic slides, the rod holder can easily be positioned anywhere
along the bench seat rail. The round hole design allows you to set
your rod and any position desired. By turning your rod in the hole and
by sliding the assembly in the seat rail, you will be able to find your
most desired position. Rod holder(s) should always be removed dur-
ing transport so the do not get damaged and so a travel cover acces-
sory can snugly fit over the shelter for transport. Simply unhook the
plate from the mount. The mount can stay in the bench seat rail.
STORAGE TRAy
The exclusive built-in storage tray runs the entire length of the bench
seat so you have ample storage of rods, bait, beverages, the remov-
able rod holders and more. Its left open for you to customize to your
liking. If you want to add foam blocks, or partitions, it can easily be
done yourself so you can customize it just the way you want. The du-
rable design will protect your small gear from the large gear you may
be storing in the ice shelter sled like buckets or ice augers.
lONG TERm STORAGE
• Always make sure your ice shelter is completely dry before stor-
ing for long periods of time. Storing your ice shelter when damp
or wet may cause mold and mildew damage.
• Remove skin, padded seats and padded backrests from ice shel-
ter sled and poles. Clean all salt, moisture and debris from your
shelter skin.
• Store skin, padded seats and padded backrests in a cool, dry
place away from rodents.
• Clean all salt, moisture and debris from the sled and poles of your
shelter. Wipe down poles with WD-40 or similar types of silicon to
deter from corrosion.
NOTE: Before attaching skin for use, re-wipe the poles to re-
move excess Wd-40 or silicon substance to deter from dam-
age to your skin.
• Store poles and sled in a cool, dry place.
gear table
rod holder
storage tray