ENMET RECON/4 - Manual (Page 3)

RECON/4 ENMET Corporation
1
1.0 Introduction
The RECON/4 is a portable multi-gas detector, monitoring continuously and simultaneously. It is widely used in areas where
explosion-proof instruments are required or possible toxic gas leaks. Examples: underground tunnels or mining industry. For
the protection of the life, health and avoid damage of equipment.
N OTE : All specifications stated in this manual may change without notice.
1.1 Unpack
Unpack the RECON/4 and examine it for shipping damage. If such damage is observed, notify both ENMET customer service
personnel and the commercial carrier involved immediately.
Regarding Damaged Shipments
N OTE : It is your responsibility to follow these instructions. If they are not followed, the carrier will not honor
any claims for damage.
This shipment was carefully inspected, verified and properly packaged at our company and delivered to the carrier in
good condition.
When it was picked up by the carrier at ENMET , it legally became your company’s property.
If your shipment arrives damaged:
•
Keep the items, packing material, and carton “As Is.” Within 5 days of receipt, notify the carrier’s local office and
request immediate inspection of the carton and the contents.
•
After the inspection and after you have received written acknowledgment of the damage from the carrier, contact
ENMET Customer Service for return authorization and further instructions. Have your Purchase Order and Sales
Order numbers available.
ENMET either repairs or replaces damaged equipment and invoices the carrier to the extent of the liability coverage,
usually $100.00. Repair or replacement charges above that value are your company’s responsibility.
The shipping company may offer optional insurance coverage. ENMET only insures shipments with the shipping
company when asked to do so in writing by our customer. If you need your shipments insured, please forward a written
request to
ENMET Customer Service.
Regarding Shortages
Items included with the RECON/4
Instrument
Charger
Calibration Cover
Screwdriver
Alligator Clip
Manual
If there are any shortages or questions regarding this shipment, please notify
ENMET Customer Service within 5 days of receipt at the following address:
ENMET Corporation
680 Fairfield Court
Ann Arbor, MI 48108
734-761-1270 734-761-3220 Fax
1.2 Check Order
Check, the contents of the shipment against the purchase order. Verify that the RECON/4 is received as ordered. If there are
accessories on the order, ascertain that they are present. Check the contents of calibration kits. Notify ENMET customer
service personnel of any discrepancy immediately.
1.3 Serial Numbers
Each RECON/4 is serialized. These numbers are on tags on the equipment and are on record in an ENMET database.