EMM Labs TSD1 CD/SACD TRANSPORT - Manual (Page 16)

016 Appendix A - Serial Remote Control (RS232)
© 2010 EMM Labs Inc., All Rights Reserved. EMM Labs reserves the right to amend specifications & design without notice.
TSD1 CD/SACD TRANSPORT OWNER’S MANUAL
Commands to the TSD1 (cont`d)
Status bytes sent from TSD1
The TSD1 sends back 9 Bytes terminated with a whenever any status changes.
Byte 0 Seconds ones in ASCII
Byte 1 Seconds tens in ASCII
Byte 2 Minutes ones in ASCII
Byte 3 Minutes tens in ASCII
Byte 4 Hours ones in ASCII
Byte 5 Track number ones in ASCII
Byte 6 Track number tens in ASCII
Byte 7
bit 0 - 1 when "Reading" indicator is on (front panel)
Command Function
dim Toggles through display brightness settings
try Tray open and close
tr(x) tr followed by a single digit (x) to jump to a particular track. See example.
tr(x) example:
a) Jump to track 5 : tr0, tr5
b) Jump to track 12 : tr1, tr2
c) For SACDs, function would be quicker if implemented this way:
i. Jump to track 5 : tr0, tr0, tr5
ii.Jump to track 12 : tr0, tr1, tr2