Elenco Logic Probe Kit - Manual (Page 9)

r Install the power cord as shown in Figure 9. Solder the red wire to hole
marked “+” and the green wire to the hole marked “–” (see Figure 9).
r Install the probe tip as shown in Figure 10. Using the 1 1/2” wire, strip 1/4”
of insulation off of both ends. Solder one end to point P on the PC board.
Solder the other end of the wire to the probe tip groove.
r Install the two labels to the case, as shown in Figure 11. Be careful to place
the labels on neatly and correctly. Peel the backing off to expose the glue.
r Place the PC board assembly into the case as shown in Figure 11. Use two
#4 screws to hold the case together. Do not over-tighten or the holes may
strip out.
r Cut a 13/16” piece of red shrink tubing and slide it over the probe tip until
it touches the plastic case. Shrink the tubing by heating it with your
soldering iron. Be sure the soldering iron does not contact the tubing or
plastic case.
This completes the assembly procedure. Your Logic Probe is now ready for
testing.
-8-
Figure 11
Top label
Top case
Assembled
PC board
Bottom case
Bottom label
#4 x 5/8” Screw
#4 x 5/8” Screw
Figure 9
Figure 10
Green wire
(to – hole)
Red wire
(to + hole)
Red shrink tubing