beautypg.com

2unpacking the pd 1, The contents of the carton, Set up procedure – Electrocompaniet PD 1 User Manual

Page 2: How to avoid damages, How to avoid noise problems, How to power up your system, When switching off your system

background image

2

Unpacking the PD 1

Immediately upon receipt of the PD 1, inspect the carton for possible dam-

age during shipment. The carton and packaging have been designed to

provide the safest possible protection for transport of your DAC. Unpack

the unit carefully. Save all packaging materials for future shipment.

The contents of the carton

• 1 pc. Electrocompaniet PD1

• 1 pc. AC main cord.

• 1 pc. inspection card

• 1 pc. remote control.

• 2 pcs. batteries.

Set up procedure

Before connecting the PD 1 to the mains, check that the main voltage

indicated on the rear panel corresponds to the line voltage in the terri-

tory where you intend to use the unit.

How to avoid damages

Do not under any circumstances connect or disconnect equipment when

power is turned on. The design of the RCA plug generates a huge tran-

sient when inserted. Connecting or disconnecting equipment with the

power on can result in severe damage to both speakers and amplifier.

How to avoid noise problems

The PD 1 contains delicate circuits that are sensitive to magnetic stray

fields. The unit should not be placed near main transformers, TV sets,

etc. Care should also be taken regarding placement of the interconnect

cables. Do not run interconnect cables in parallel with main cords or

speaker cables. Keep interconnect cables as short as possible

How to power up your system

You should always power up your system in the following way:

Signal sources (CD player, tuner, etc.) first, then the PD 1 and then the

amplifier.

When switching off your system

First turn of the amplifier, then the PD 1 and the sources.

PD1DAC_Manual_R1.indd 2

25.10.2010 12:19:13