Electrocompaniet PI 2D - Manual (Page 2)

2
ENG
Unpacking the PI 2D
Immediately upon receipt of the amplifier, inspect the carton for possible dam-
age during shipment. If the carton is visibly damaged, a claim must be filed
with the carrier as soon as possible.
Unpack the unit carefully, and please do remember to save all packaging
materials for future shipment. The carton and packaging have been designed to
offer the safest possible protection when transporting your amplifier.
The contents of the carton
• 1 pc. Electrocompaniet PI 2D Integrated Amplifier
• 1 pc. AC power cord
• 1 pc. Owner's Manual
• 1 pc. Inspection Card
• 1 pc. Remote control
• 2 pcs. batteries.
Set up procedure
Before connecting the PI 2D to the mains, check that the main voltage
indicated on the rear panel corresponds to the line voltage in the terri-
tory where you intend to use the unit.
How to avoid damages
A good operating practice is to turn off all equipment before any con-
nections or disconnection’s are made. Do not under any circumstances
connect or disconnect equipment when power is turned on. The design
of the RCA plug generates a huge transient when inserted. Connecting
or disconnecting equipment with the power on can result in severe
damage to both speakers and amplifier.
How to avoid noise problems
The PI 2D contains delicate circuits that are sensitive to magnetic stray
fields. The unit should not be placed near main transformers, TV sets,
etc. Care should also be taken regarding placement of the interconnect
cables. Do not run interconnect cables in parallel with main cords or
speaker cables. Keep interconnect cables as short as possible.
How to avoid possible antenna problems
In some setups hum may occur when you connect the radio, VCR or TV
to your system. The problem is caused by DC voltage coming from your
antenna. Please contact your cable network operator.