Echelon NodeLoad Utility - Manual (Page 9)

Passing Result
This result message indicates passing results and returns the NID of the loaded node.
Nodeload Result: Success; NID=050001020300
Failing Result
This result message indicates failing results and includes a code that specifies
the failure.
Nodeload Result: Failed (error - #x)
Error Code Reference
Error codes for the NodeLoad utility (error - #x) are defined in the
following table.
Error Code Error Title Description
1 No nodes found The “-Q” switch was specified and no devices were
found during the query.
2 Service pin timeout The “-W” switch was specified and no service pin
message was received.
3 Comm failure A communication failure occurred either on initial
contact with the “-N” switch or subsequent contact in
any mode.
4 File error The NDL file was not found or was corrupted.
5 Reset failure Nodeload could not successfully cause the node to
reset. This could indicate an excessively long reset
clause in the application.
6 Buffer failure Nodeload could not successfully configure the buffers
on the network interface.
7 State failure The device could not be successfully put into the
correct state at the end of the load.
8 Checksum failure The device failed to set its checksum after the load.
9 Version mismatch The device firmware version didn’t match the firmware
version that the NDL file was linked for.
10 Model mismatch The device model number (that is, part type) did not
match the model number that the NDL file was linked
for.
11 Interface error The network interface (for example, U10) could not be
communicated with.
12 Response error The device reported a failing response. This could be
due to an authentication key mismatch or a failure to
write non-volatile memory.
NodeLoad Utility User’s Guide 6