Echelon NodeLoad Utility - Manual (Page 7)

Argument Description
-O Redirect the NodeLoad output string to the file specified.
-Ofilename.txt
-Q Send a query for unconfigured devices on the network and program the
first device found.
This argument is the default if none of –N, -W, and –Q are specified.
Note: This method is not recommended when building power line-based
devices unless the NodeLoad station has a good power line
communications isolator.
-U Specify the 6- or 12-byte authentication key used to unlock a previously
authenticated device.
-U474D52445746
-U4B4953534D59475249545321
-V Set to verbose mode.
-W Wait for a service pin message before downloading. If no service pin
message is received within the specified time, NodeLoad exits. For
example, to wait 5 seconds for a service pin message, use the following
command:
-W5
-X[] Update transceiver parameters using those found in the file specified in
–L above or in the -X if the optional argument is
specified.
-Xmyapp.ndl
Note: If –L is not specified, then the argument becomes
required for the –X option.
-Z Specify 0-, 1-, 3-, or 6-byte domain ID. Leave the argument empty for the
zero-length domain.
-Z -> zero-length domain
-Z14
-Z020812
-Z140923100523
-# Force a larger buffer for faster downloads. NodeLoad will ignore this
option if it is not safe.
-! Bypasses the transceiver-compatibility check of the image to be
downloaded. Normally, NodeLoad checks that the image file is compatible
with the transceiver before it loads the image.
Note: Do not use this option if you have any doubt about the transceiver-
compatibility of your image file. An incompatible image can damage a
transceiver.
NodeLoad Utility User’s Guide 4