Ditch Witch 100SX - Manual (Page 39)

100sx - MAINTENANCE 39
TIRES AND LUGNUTS
100sx - MAINTENANCE 39
TIRES AND LUGNUTS
TIRES AND LUGNUTS
Check tires every 10 hours for proper inflation. Use an accurate
pressure gauge. Maintain air pressure at 15 psi (10.3 kPa).
Tighten lugnuts to 32 ft•lb (43.2 N•m).
For machines with serial numbers below 4R0376, tighten castle
nut firmly, then align castle nut slot with pin hole and insert cotter
pin. If wheel will not turn without binding, loosen nut to next slot
that aligns with hole. Reinstall cotter pin.
AIR FILTER ELEMENTS
Wash foam element (2) every 25 hours
in high flashpoint solvent.
NOTICE: Do not use gasoline or low
flashpoint solvent for cleaning. They
are flammable and are explosive under
certain conditions.
Change paper element (1) every 100
hours.
TIRES AND LUGNUTS
Check tires every 10 hours for proper inflation. Use an accurate
pressure gauge. Maintain air pressure at 15 psi (10.3 kPa).
Tighten lugnuts to 32 ft•lb (43.2 N•m).
For machines with serial numbers below 4R0376, tighten castle
nut firmly, then align castle nut slot with pin hole and insert cotter
pin. If wheel will not turn without binding, loosen nut to next slot
that aligns with hole. Reinstall cotter pin.
AIR FILTER ELEMENTS
Wash foam element (2) every 25 hours
in high flashpoint solvent.
NOTICE: Do not use gasoline or low
flashpoint solvent for cleaning. They
are flammable and are explosive under
certain conditions.
Change paper element (1) every 100
hours.