Display Devices Lifts up up 400 lbs - Manual (Page 24)

1/17/07 24
Set the SERVICE / MAINTENANCE position
This is lower than the SHOW setting, bringing the lift to a level making maintenance,
service, lamp and filter changes, and projector adjustments easier. Be sure to start this
procedure from the HOME position.
1. Program the remote to MANUAL MODE – (OVERRIDE + UP). Press and hold
the OVERRIDE button, then press the UP button. Release UP, and then
release OVERRIDE.
2. Lower the lift with the DOWN button to its desired position for the easiest
access for maintenance and repair.
3. To program the remote to the SERVICE/MAINTENANCE position, press and hold
the SET button, followed by the STOP button. Release the STOP, and then
SET buttons.
4. To return the remote to the AUTOMATIC MODE, press and hold the OVERRIDE
button, followed by the STOP button. Release the STOP, and then OVERRIDE
buttons.
5. Return the lift to the HOME position by pressing the UP button once.
6. Test the operation of the lift to verify it has accepted your program. Press and
hold the OVERRIDE button, followed by the DOWN button. The lift will travel
to its programmed position.
Remember, the remote must be in AUTOMATIC MODE for the programmed positions
operate correctly.
Return to AUTOMATIC MODE
1. Press and hold the OVERRIDE button, followed by the STOP button. Release the
STOP then OVERRIDE buttons.
In the AUTOMATIC MODE, the lift will automatically descend to the proper show level,
rise to the HOME position, and descend to its lower limit service and maintenance.
Front Back
UP
DOWN
STOP
SET
These two bottoms are accessed with a small point
OVERRIDE