Warning, Ethernet – ip configuration, Step 1 – DaySequerra Remote Dashboard User Manual
Page 4
4
Ethernet Configuration Guide
Ethernet – IP Configuration
your unit.
Connect your Windows XP - SP2 host PC to the MAM, M2 or M4 unit using a crossover cable or
through an Ethernet hub connected directly to your unit and proceed with the following
instructions to change your DaySequerra unit’s IP address:
STEP 1
Note: The host PC and the DaySequerra unit must be on the same TCO network and subnet:e.g.,
192.168.2.X and 255.255.255.0
WARNING!
Do not attempt to configure your DaySequerra unit over the Internet
or on an Ethernet network! Network traffic may corrupt your unit.