DaySequerra Remote Dashboard - Manual (Page 10)

10
Ethernet Configuration Guide
Enable Preset Scan – will allow you to scroll through all of your stored preset stations. Enter the time
in seconds that you would like to remain on each station in the Dwell box.
NOTE: The Preset stations that are stored in the Remote Dashboard application are NOT the same
presets that are stored on your DaySequerra unit.
Alarm Status – White indicates that no alarms have been enabled
Green indicates that there are alarms enabled
Red indicates that an alarm has been triggered and will be listed in the boxes below
See figure 3.0
Remote IP Connection – White indicates that there is no Remote IP connection established
Green indicates that the Remote IP has been connected
IP Address – enter the IP address of the unit that you are trying to connect and press
the connect button
Analog RF Signal Strength – White indicates that no analog signal is present
Green indicates that an analog signal is present
RF Level – indicatesthe current level of the analog signal in dBf
Alarm Under – enter the threshold that you would like to set the alarm if the signal
strength falls below and press the SET button under alarm
Digital Program Status – Each box from HD-1 to HD-8 will light Green for all of the available HD
signals present for the current station. You can select one Digital Audio signal at a time. HD-1 is the
default. The Digital Audio will indicate Green on the selected HD signal. To switch the HD-2 to HD-8
press the Select button
under the desired box. Once the HD signal switches and is locked the
indicator will change from White to Green.
You can alarm the digital signal present for the HD signal that you have selected by pressing SET
next to the Alarm in each box.
Program Alarm – once you have set any alarm in any box you must press Enable to have the
Alarms become active. To Disable all of the alrams set, press Disable.
See Figure 2.0
Once an alarm has been triggered it will be displayed in the Alarm Status box. To clear the alarms
press the Clear All button.