DaySequerra M4.2 TimeLock - Manual (Page 20)

20
M4.2Si TimeLock User Manual
Network Tab
Figure 16.
• Network Settings - Configures network connections. DHCP is enabled by default.
Slide the switch to the right box to disable DHCP. IP Address, IP Subnet, Gateway are
set here. MAC is read only. After the Network settings are saved the M4.2 TimeLock™
will reset itself so the new network settings are enabled.
• Private FTP Settings – An optional private FTP may be setup for firmware updates. By
default this feature is disabled. Slide the switch to the left indicated in orange to Enable
private FTP.
• Email Notifications Settings - configures the M4.2 TimeLock™ for email alerts when
Alarm conditions become active. This feature is set to disable by default. Slide the
switch to the left indicated in orange to enable. Entering the SMTP IP, Port, User
Name, Password, Sender, and Receiver is required. Click ‘Save’ when finished.
Network Settings Private FTP Settings Email Settings